They are made from the same metal as the contacts in the tail ight sockets. ![]() The spade lugs and connectors are not conformal coated and have very small surface area for the high current connection. No hoild downs, screws, anything.just held in place. ![]() The regulator board is connected to the blower with 4 spade lugs. Then saw the issue.which might be the problem with most units. Even if were wet, there should be no impact. I saw the typical corrosion, but also noticed the board is also conformal coated. Removed the blower, area was dry and removed the 2 screws holding the cover in place for the regulator board (its not just a resistor, its a full board with many components). Thought I would change just the board since the blower was running which meant it's ok. Removed the blower motor and was searching E-Bay for a replacement. ![]() 2008 ML 550, blower runs with the key off. I thought I would pass this on for what it might be worth.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |